Rugged Cams Rugged Vision DVR - Manual (Page 49)

Sensor
Under Sensor setup, you can modify
sensor settings, view sensor logs and
enable sensor onboard.
Procedure Using the Remote Control-
ler or Control Panel:
1. In SETUP, select Event->Sensor.
2. In Sensor Setup, use [UP], [DOWN], [LEFT] or [RIGHT]
to navigate through the menu.
3. Use [ENTER], [SELECT], [+] or [-] to change the values.
The status may be enabled or disabled. The normal state may
either be close or open. Note that all changes you make are always
saved.
4. When you are done, press [SETUP] or [BACK].
Under sensor logs, you can view the list of recorded information or
events collected by a sensor (or set of sensors).
It will automatically log the
sensor(s) that triggered and
the date it triggered.
Sensor On-board option determines the sensors you are using.
Enabling it means you will use the built-in 4 sensors on the board,
while disabling it means you will use the 8 sensors in the extended
IO card (i.e. if you add an IO card to the board).
49