Rugged Cams Rugged Vision DVR - Manual (Page 50)

Relay
Under Relay setup, you can modify relay
settings. A relay may be reset or returned to its
original state in 3 different ways – time-based,
sensor-synchronized or manual. With
time-based reset, the relay will be reset after a
specified duration (in seconds). With
sensor-synchronized, the relay will be reset
when the corresponding sensor is reset. With
manual reset, the relay will be reset only with
manual intervention.
Procedure Using the Remote Control-
ler or Control Panel:
1. In SETUP, select Event->Relay.
2. In Relay Setup, use [UP],
[DOWN], [LEFT] or [RIGHT] to navigate
through the menu.
3. Use [ENTER], [SELECT], [+] or
[-] to change the values. The reset mode
may be time-based, sensor-synchronized
or manual. Duration ranges from 5
seconds to 60 seconds in increments of 5
seconds. Note that all changes you make
are always saved.
4. When you are done, press [SETUP] or [BACK].
Motion
Motion settings allow you to select area or
adjust zones of motion detection for each
camera. The image below shows all areas
are selected for motion detection.
50