Rugged Cams Vertex & Vertex RTH - Manual

Quick
Reference
Guide
RUGGED CCTV
IN16
IN15
IN14
IN13
IN12
IN11
IN10
IN9
GND
GND
IN8
IN7
IN6
IN5
IN4
IN3
IN2
IN1
GND
GND
CO
M
OUT4
CO
M
OUT3 OUT2
CO
M
OUT1
CO
M
TR
X-
TR
X-
TR
X+
TR
X+
PTZ Terminal Block
Only the far right TRX+ and TRX- terminals are used for PTZ RS485 connectors
(Pinout will be slightly different based off the # of camera channels your DVR has)
DIO/RS485
Default Settings for the Vertex DVR
• All Cameras are enabled and recording continuously 24/7
• Motion Detection if enabled is set to look at the entire screen and the sensitivity is set to Medium.
• Date and Time info (can be changed one at a time from Menu/MainSetup/Date & Time and then over
to Date & Time)
o Date – internal time clock will bring up the correct date when system is powered
o Time – set to (GMT – 06:00) Central Time
o NTP Time Server is Off
• Network Settings (Statically assigned through the Rugged CCTV test network)
o IP Address – 192.168.1.12
o Subnet Mask – 255.255.255.0
o Default Gateway – 192.168.1.1
o Both DNS #’s completely left as 0’s
o These will more than likely need to be changed to be able to communicate with the
customers network
• User names and Passwords (these can be Modifi ed/Added/Deleted from Menu/Main Setup/System/
User Level)
• At the DVR
o Admin and 00000
o User1 and 1111
o User2 and 2222
o User3 and 3333
o User4 and 4444
• On the CMS remote software – the initial Administrator password is 1111111, and when
you are adding your DVR into the address book the user name is user1 and 1111111 for the
password
RUGGED CCTV
201 North Elm Street, Kemp, Texas 75143
1-866-301-CCTV
Phone: 903-498-3240 • Fax: 903-498-8989
www.rugged-cctv.com
[email protected]