Rugged Cams Rugged Vision DVR - Manual (Page 41)

To Update the Version of your DVR Server, please follow the steps below:
1. Under System settings, select Tools->Update DVR.
2. Press [UP] or [DOWN] to select update
either by Network or Flash Disk and press
[ENTER/SELECT]. If you choose updating by Flash
Disk, make sure the Flash Disk is properly attached to
the USB port.
3. If you choose updating by Network, enter
the Server IP and password and press [ENTER/SE-
LECT]. Press [UP] or [DOWN] to move between
fields. Use the numeric keys on the remote controller
to input data, or press [ENTER/SELECT] while the
fields are empty to use the On-Screen Keyboard.
4. A confirmation message will pop up. Select YES to update or NO if you do not want to update.
(Make sure that your DVR can connect to the Server IP. Check your network settings.) The total length
of update will take about 10~15 minutes via LAN connection.
5. You will need to restart your DVR to before the changes will take effect. Push the reset button
of the DVR to reboot.
Please contact your nearest distributor for the Server IP and password.
41