Rugged Cams Rugged Vision DVR - Manual (Page 25)

Manual / Forced Recording
Procedure Using the Remote Controller:
Press [RECORD] to start manual or forced
recording. Press [RECORD] again to exit or
stop recording.
Procedure Using the Control Panel:
1. In LIVE VIEW, press [MODE].
2. Select Forced Recording by pressing [SELECT]. This will bring you back to LIVE VIEW. The Forced
Recording icon will indicate that the DVR is currently on forced recording mode.
3. In LIVE VIEW mode, press [BACK] to stop recording. In other modes such as SETUP or SEARCH,
pressing [BACK] will not stop the recording.
Live Audio
Procedure Using the Remote Controller:
1. Press [AUDIO] to modify audio settings. Press on [LEFT], [RIGHT], [+] or [-] to increase or decrease
output volume.
2. Press [1], [2], [3], or [ENTER] to select audio channel.
3. Press [AUDIO] again to exit.
4. Press on [FREEZE] to mute output volume.
Procedure Using the Control Panel:
1. In LIVE VIEW, press [MODE].
2. Select Audio by pressing [UP]/[DOWN] then [SELECT].
3. Press on [LEFT] or [RIGHT] to increase or decrease output volume.
4. Press [SELECT] repeatedly to switch audio channels.
5. Press [BACK] to go back to LIVE VIEW.
25