Epson Action Laser II - Manual (Page 86)

SelecType Options
MODE ASSIGN
This option allows you to choose one of the three operating (or
emulation) modes.
* LJ-2P
LQ
FX
The HP emulation mode offers the widest range of features, but you
may also want to select the other modes to use software written
specifically for other printers. You must change
the
MODE ASSIGN
setting before you can operate your printer as an Epson LQ or FX
printer.
Press . The following display appears:
When you change
the
printer mode, you first select a channel, P
(parallel), S (serial), or 0 (optional). Optional appears only if you
have installed an optional interface. Press until the channel you
want to
choose
appears; then press
.
Press
D
to set the
new
mode. This mode remains in effect until you
change the setting again or turn off the printer. If you want
this
setting to remain in effect even after you turn the printer off and
back on, use
the
P-CONFIG SAVE option to save the setting as
described later in this chapter.
4-22 SelecType