Epson Action Laser II - Manual (Page 232)

Optional Epson GL Identity Card
Using the Epson GL identity card
To run the EPSON GL printer mode after inserting the identity card,
follow these steps:
1. Press SelecType until SelecType LEVEL2 appears on the display.
2. Press until MODE ASSIGN appears.
3. Press
.
4. Press or to select a channel for Epson GL mode.
5. Press
.
6. Press or until EPSON GL appears.
7.
Press to set the mode.
8. To exit SelecType, press the SelecType button.
Note: Once you set an option, the setting remains in effect until
you change it again or turn off the printer. If you want a setting to
remain in effect even when you turn the printer off and on, use
the P-CONFIG SAVE option in SelecType Level 2. See Chapter 4.
There are several restrictions on using the Epson GL identity card
with this printer.
Device control commands are ignored with optional interfaces
even if the interface is serial. Use the printer’s serial interface to
enable
the
additional device control commands.
The following restrictions apply when running the Epson GL
mode using Channel S with the AUTO-SENSE setting.
The power-on default channel becomes Channel S.
Channel S cannot receive any data
when
another channel is
running.
Channel S can be selected only
when the FEED
light is turned off.
A-24 Options