Epson Action Laser II - Manual (Page 168)

SelecType Problems
SelecType does not function as expected.
Settings made with SelecType are ignored.
You may not have saved your settings before turning off or
resetting the printer. Make sure you save your settings with the
SYSTEM CONFIG option SAVE MACRO setting in SelecType
Level 1 or with P-CONFIG SAVE in Level 2.
Once you save
Level 1 settings in a macro, you also select a correct macro
number with POWERON MACRO, or SelecType settings return
to their previously-saved default settings after you turn off or
reset the printer.
You may have saved settings to the same macro number in two
or more channels. Never save settings to the same macro number
in different channels or the
settings
in one channel
may
affect the
settings in another channel.
The software may either be changing the defaults on the printer
or initializing the printer. This may require that you change the
initialization sequence sent by your software. See your software
manual for more information. You
can
probably make any
necessary setting with your software.
You may be trying to set certain combinations of settings with
SelecType that cannot be acted on by the printer. Usually,
SelecType does not allow you to make incompatible
combinations. However, certain combinations are not checked
for compatibility until after you exit SelecType and set the
printer on line. Others are
not
checked at all. See Chapter 4 for
more information about SelecType.
Troubleshooting 7-23