Epson Action Laser II - Manual (Page 85)

SelecType Options
Level 2 options
When you press and hold down the SelecType button for a few
seconds (until the SelecType LEVEL2 message appears on the
display) to enter Level 2, one of the main menu options listed below
appears on the display:
TEST PRINT
MODE ASSIGN
I/F CONFIG
RX-BUFFER SIZE
CH
CH TIMEOUT
AUTO CONT
P-CONFIG SAVE
FACTORY RESET
VERSION
PAGE COUNTER
STANDBY
Each of these options is described below. An asterisk (*) indicates the
factory default setting, if there is one.
TEST PRINT
Print two different test patterns to check whether your printer is
working correctly. After TEST PRINT appears, press once to see
the following display:
Press to print Pattern 1 (vertical lines) or press to display
Pattern 2 (horizontal lines); then press to print Pattern 2.
SelecType
4-21