Epson Action Laser II - Manual (Page 66)

SelecType Overview
The SelecType function on the printer control panel allows you to
print test pages, display memory size, select paper sizes, and change
your printer’s configuration without using DIP switches or software
commands. However, use SelecType only when you are unable to
use your application software to control settings required for your
print job.
Note: New SelecType settings are in effect only until you turn off
the printer unless you save them with the Level 1 SYSTEM
CONFIG option or the Level 2 P-CONFIG SAVE option described
later in this chapter.
SelecType is divided into two levels as shown below. A brief
description of each main menu option follows. See SelecType
Options later in this chapter for detailed descriptions of all
SelecType options.
Level 1
CH SELECT
INPUT
P-SIZE
COPIES
ORIENT
FONT
STATUS SHEET
FONT SAMPLE
SUB CONFIG
SYSTEM CONFIG
Level 2
TEST PRINT
MODE ASSIGN
I/F CONFIG
RX-BUFFER SIZE
CH
CH TIMEOUT
AUTO CONT
P-CONFIG SAVE
FACTORY RESET
VERSION
PAGE COUNTER
STANDBY
Note: See the Quick Reference card at the back of this manual for
a map of SelecType menus and options.
4-2 SelecType