Epson Action Laser II - Manual (Page 233)

Optional
Epson GL Identity Card
Removing a card
CAUTION: Never remove a card while the printer is
on line, in SelecType mode, or while
the
printer is
resetting. If you remove a card while the-printer is in one
of these states, a REINSERT CARD message appears on
the display. An error also occurs if you remove a card
while the
FEED
light is on,
even
if
the
printer is off line. See
the description of card error messages in Chapter 7 for
more information.
1.
2.
3.
4.
Make sure that the printer is not in one of the following
conditions:
The
FEED
light is flashing fast (the printer is receiving data
through the currently-selected interface). You are setting
parameters using SelecType. The display shows
the message
RESET.
If
the FEED
light is on, take the printer off line and press
FEED to
print any data remaining in the buffer.
Set the printer off line (make sure the
ON LINE
light is off) or turn
off the power.
Remove the card by grasping the card at the center and gently
pulling it straight out of the slot.
Options A-25