Epson Action Laser II - Manual (Page 49)

Testing the Printer
3. Press until STATUS SHEET appears on the display.
4. Press
D
twice to print the status sheet. A sample printout is
shown below.
Printer Configuration
STATUS SHEET EPSON
Installed Memory : 3.OMbytes Controller Version : 15.04
CH Mode : AUTO-SENSE CH Time out : 28
Auto Continue : OFF Total Printed Count: 25
Standby : DISABLE
CH : P
Mode : LJ-2P Version
I/F : PARALLEL
PARALLEL (CH P)
SLCTIN : OFF AUTOFEED : OFF
SERIAL (CH S) : RS232C
Word Length(bit) : 8 Baudrate(bps) : 9600
Stop Bit : 2 DTR : ON
DSR : OFF CTS : OFF
Receive Buffer : 1kbytes
Mode Configuration
Input Tray : AUTO Font : RD-0
Copies : l Orientation : PORT
Sub Configuration
Form Length : 60 Symbol Set : Roman-S
: 17.04
BUSY Delay(µs) : 0
Parity
XON/XOFF
ENQ/ACK
: NONE
: ON
: OFF
Paper size : LETTER
System Configuration
Top Offset : 0
Full Print : 0
Load Macro : 0
Left Offset : 0
Memory Left : 2949Kbytes
Power On Macro : 0
Note: The status sheet prints the printer’s current settings,
including any new macro settings. See Chapter 4 for information
on macro settings.
5. Press the SelecType button twice to exit SelecType.
If the status sheet does not print properly, see Chapter 7 for
troubleshooting information.
Testing and Connecting Your Printer 2-9