Epson Action Laser II - Manual (Page 240)

Using the Font Cartridges
CAUTION: If the message REMOVE CARD appears on the
display, you inserted the cartridge when
the
printer was
on line or when the printer’s memory contained data. If
you see this message, remove the cartridge, press
CONTINUE;
then return to
step
1.
6. If the power is
on,
press
ON LINE
to set the printer on line. If the
power is off, turn
on
the printer.
Now that you have inserted a font cartridge, you can select the fonts
you want to print using your application program or SelecType.
Selecting a font with your application program
When
the
printer is in HP emulation mode, you can use your
application program to select the fonts you want to use. First be sure
you selected HP LaserJet IIP or a similar printer
from
the program’s
setup or installation menu. For more information on which printers
to choose when you set up your application program, see Using
Your Printer with Application Software in Chapter 3. After you set
up your application program, you can specify the fonts you want
using the commands available in the program.
If your program does not provide commands that allow you to select
the font you want, you can select fonts using SelecType menus or
printer command sequences. Most application programs, however,
allow you to select fonts, and you should
not have to
use SelecType
or printer commands to do so. To select a font using SelecType, see
Choosing a Font, Chapter 4. For information on printer commands,
see Appendix D. Also see your software manual for information on
how
to use printer command sequences.
B-6 Font Cartridges