Epson Action Laser II - Manual (Page 166)

Problems With Graphics
Graphic images do not print.
After changing the printer mode, you are unable to print graphics.
You may not have the correct printer driver installed. If you try
to print with a software package set for another printer, nothing
will be printed. Make sure that the driver matches the currently
selected printer mode as described in Chapter 3.
You cannot print graphics using the serial interface.
The WORD LENGTH setting in the I/F SERIAL option of
SelecType Level 2 may not be set correctly. When printing
graphics, make sure that you set an 8-bit data word and not a
7-bit data word.
When printing a mix of text and graphics, the page does not print
or
is
only partially printed. The display may also show SET FULL PRINT.
The full print buffer setting needs to be changed. To correct this
error, change the FULL PRINT setting in the SYSTEM CONFIG
option of SelecType Level 1 as described in Chapter 4.
Graphics cannot be printed and the display shows PAGE
BUFFER FULL. The full print buffer or the receive buffer setting
needs to be changed. To correct this error, change the FULL
PRINT setting of the SYSTEM CONFIG option in SelecType
Level 1 or the RX-BUFFER setting in SelecType Level 2 as
described in Chapter 4.
Your printer may not have enough memory installed. You need
to simplify the page or install additional memory. Press
CONTINUE to clear the error. For information on adding memory,
see Appendix A.
Troubleshooting 7-21