Emulex DCP_link User Manual
Page 63
Software Installation 4-3
After a short delay, the Installation Options menu appears.
Figure 4-3 Installation Options Menu
Select
Install on Local Server Only
, then press
The INSTALL program copies several files from the INSTALL diskette
to a local directory.
5)
When the source files have been copied, the following message is
displayed:
Installation was successful. Bring down and restart each
server on which you installed the software to ensure that it
uses the newest NLM files.
6) Press
7) Select
Display Log File
after install to check for any installation
problems. A list of files that were not installed (for any reason) will be
displayed at the bottom of the Display Log File.
8) Select
Display README Files
for new additions or information.
9) Select
10) The list of Currently Installed Products is again displayed. Verify that
EMULEX WAN for NetWare has been added to the list.
11) Highlight EMULEX WAN for NetWare and press
the Internetworking Configuration menu.
12) You are now ready to configure the Emulex DCP_link adapter and create
specific WAN links. Please turn to Chapter 5, Software Configuration
to continue.