Emulex DCP_link - Manual (Page 129)

A-2 Appendix A
This section describes the operation of the diagnostic program. This program
tests all functions of the DCPx86i/e, including on-board memory and
registers, host memory, interrupts to and from the adapter, and the
microprocessor. For DCP286i-SBC and DCP486e adapters, use the
following DIAGNOSTIC PLATFORM. For the DCP386i adapter, go to the
section entitled DCPDIAG3.
Diagnostic Platform
Diagnostic Operating Requirements
To run diagnostics for test and verification of DCP286i-SBC and DCP486e
adapters, the minimums requirements are:
• IBM PC, PC/AT, PC/XT, or compatible
• 640KB of RAM
• A floppy diskette drive
• DOS version 3.0 and above
Some tests that are NOT selected by default may require loopbacks or null
modems.
README.DOC
The README.DOC file is a non-executable file which contains an
explanation of each diagnostic program on the diskette. To read the file,
place the diskette in drive A and type:
> A:README. DOC
⎜ MORE
To scroll through the display, press the spacebar. To exit this file at any time,
press C.