Emulex DCP_link - Manual (Page 108)

X.25 Configuration 7-15
Local DTE Address
1) Enter the access address provided by your local X.25 network service
provider.
NOTE: You can leave the configuration at this point by
accepting the default values for the remaining
parameters. To save this configuration and return
to the Internetworking Configuration menu, press
, select Yes when prompted, then press
.
2) Statistics Period - Specifies the interval (seconds) that the network
interface (port) is interrogated by the driver for statistical information.
3) Interface Queue Limit - Specifies the maximum number of data packets
that can be queued to this port. The range of values is 0 (unlimited)
through 1024 packets. The default value is 100 packets. Selecting 0
disables the queue limit, allowing unlimited queue depth.
NOTE: The Interface Queue Limit value must be less than
the Maximum Packet Receive Buffers as defined in
the startup.ncf.
X.25 Authentication Options
Authentication on the X.25 link checks all inbound and outbound calls
for proper access to the local and remote server.
NOTE: If you will be using “on-demand” call destinations,
you must configure the X.25 Authentication
Options.