Emulex DCP_link - Manual (Page 111)

7-18 Chapter 7
2) The Configured Wan Call Destinations window is displayed:
Figure 7-7 Configured Wan Call Destinations
If no WAN Call Destinations have been configured, the list will be
blank.
3) Press to configure a new WAN Call Destination for X.25.
4) Enter a name for the new WAN Call Destination, then press .
NOTE: WAN network interfaces must be configured
before WAN Call Destinations may be created.
5) Select EMX X.25 as the wide area medium, then press .
The X.25 Call Destination Configuration window is displayed.
Figure 7-8 X.25 Call Destination Configuration