Bang & Olufsen BeoVision 7-40/55 User Guide User Manual
Page 8
8
>> First-time setup
Adaptive Sound Technology enabled:
SPEAKER SETUP … In this menu, you register
the speaker type in the menu. Enter the
straight-line distances from two points,
Points A and B to each speaker, to the left
and right sides of the television screen and
a projector screen, to a viewing position
and the distance between the two points.
TV … Select the speakers to be active when
you watch television and determine the
distance from your listening position to
three of the activated speakers. You can
enable Adaptive Sound Technology or set
the speaker roles and levels.
CINEMA … Select the speakers to be active
for a connected projector and determine
the distance from your listening position
to three of the activated speakers. You can
enable Adaptive Sound Technology or set
the speaker roles and levels. This menu is
only available if you have connected a
projector.
SOUND ADJUSTMENT … In this menu you
adjust volume, bass, treble, and loudness.
In addition, you can select two default
speaker combinations; one for video
sources and one for audio sources
connected to your television. You can also
select which LISTENING PRESET should be
activated when you switch on an audio
source. If you select the option MANUAL,
the preset used when switching on the
audio source continues to be active and if
all your sources are switched off, the
preset used before switching on the audio
source is automatically activated. If you
select one of your LISTENING PRESETS,
this preset is activated every time you
switch on an audio source.
SOUND SETUP … Enter the LISTENING
PRESETS menu and select a PRESET field.
Then select the speakers to be active for
different listening positions, such as at the
dining table or in a favourite armchair, and
determine the distance from your listening
position to three of the activated speakers.
You can enable or disable the Adaptive
Sound Technology and either rotate the
selected speaker setup or set the speaker
roles and level.
Continue first-time setup:
STAND ADJUSTMENT … Set the maximum
angle for turn and tilt of the television.
Use , , and to tilt and turn the
television and limit the movement of the
stand.
STAND POSITIONS … Set your preferred
preset positions for the television. For
further information about the STAND
POSITIONS menu,
STANDBY SETTINGS … The television can be
set to switch itself to standby after some
time with no operation. You can also switch
power saving on or off.
for
further information.
*If you have a Beo4 remote control without
navigation button, or if the navigation
button on your remote control is disabled,
use the green button to tilt the television up
and the red button to tilt it down.
For information about where and how to
connect extra equipment, see the chapter
about connection panels in Getting Started.