Bang & Olufsen BeoVision 7-40/55 User Guide - Manual (Page 7)

7
REMOTE CONTROL … Enable or disable the
navigation button on your remote control.
See page 61 for information about setting
up your remote control. See page 6 for
information about remote controls.*
TUNER SETUP … Disable the television tuner
or ATSC tuner, if you like, or scan in
channels and identify a connected cable
box,
see page 10 .
CONNECTIONS … Select the type of
equipment you have connected to each
socket group, the sockets used, the
product name, and the source name.
For further information about the
CONNECTIONS menu,
see page 15 .
CHECK AERIAL CONNECTION … This
prompt only appears if the television
tuner is enabled.
AST ON/OFF … In this menu, you can
choose between a speaker setup menu
with or without Adaptive Sound
Technology. The default setting is OFF.
For further information about Adaptive
Sound Technology, see page 29 .
*If you have a Beo4 without a navigation
button or if your Beo4 is not set to the
correct mode, you cannot enable the
navigation button. See the Beo4 guide or
contact your Bang & Olufsen retailer for
further information. However, do not
change mode during first-time setup,
as this will interrupt the sequence.
Adaptive Sound Technology disabled:
SPEAKER TYPES … In this menu, you select
which speakers are connected to the
television, if any.
See page 24 for further
information.
TV SPEAKER ROLES … In this menu, you
select the function for each connected
speaker in your setup, such as front,
back or surround. As you highlight each
speaker, a sound is produced by the
speaker. Check that the speaker type
highlighted in the menu matches the
speaker type making the sound.
See page 25 for further information.
SPEAKER DISTANCE … In this menu, you
select the distance in metres to each of
the speakers in your setup.
See page 26
for further information.
SPEAKER LEVEL … In this menu, you can
adjust the volume level of each speaker
in your setup.
See page 27 for further
information.
SOUND ADJUSTMENT … In this menu,
you can adjust bass, volume, treble and
loudness. In addition, you can preset two
default speaker combinations; one for
video sources and one for audio sources
connected to your television.
See page 36
for further information.
First-time setup
The setup procedure is activated
when the television is connected
to the mains and switched on for
the first time. You are led through
an automatic series of on-screen
menus in which you must register
the extra equipment you have
connected, such as a projector
and loud speakers.
If you change your setup at a later
date, you can access the same
menus and update your settings.
Remember that you need to set
the speaker types and the
distances in the SOUND SETUP
menu.
The contents of the first-time
setup sequence varies according
to the setting you make in the
AST ON/OFF menu.
The sequence of menus in first-time setup