For further information, For further, Information – Bang & Olufsen BeoVision 7-40/55 User Guide User Manual
Page 32
CINEMA
TV
32
Select the speakers to be activated in TV
mode and, if you have connected a
projector, in Cinema mode. You can also
make up to five customised listening
presets, such as at the dining table or in a
favourite armchair. Select three to seven*
speakers and up to two subwoofers to be
activated for a preset and determine the
distance from your listening position to
three of the activated speakers.
For each customised listening preset it is
also possible to rotate the perceived
sound 360 degrees around the listening
position. The default rotation is 0 degrees
which is the direction from your listening
position to the television.
If your speakers are placed correctly for
your listening positions, it is
recommended that you disable Adaptive
Sound Technology and set the speaker
roles, distances and levels. If you
activate fewer than three speakers, it is
not possible to enable the Adaptive
Sound Technology and you must set the
speaker roles, distances and levels. For
further information about speaker roles,
distances and levels,
.
*A stereo speaker such as a BeoLab 7–1 or
7–2 counts as two speakers if fewer than six
speakers are activated.
The distance from your listening position to
any speaker in a listening preset should not
exceed 10 metres.
To set speaker presets …
> Bring up the TV SETUP menu and highlight
OPTIONS.
> Press the centre button to bring up the
OPTIONS menu and highlight SOUND.
> Press the centre button to bring up the
SOUND SETUP menu and highlight
LISTENING PRESETS.
> Press the centre button to bring up the
LISTENING PRESET menu and highlight TV,
CINEMA or a custom preset field.
> Press the centre button to bring up the
highlighted menu.
> Use the navigation button left or right to
enable or disable the Adaptive Sound
Technology.
> Use the navigation button left or right to
activate the preferred speakers. Three to
seven speakers as well as up to two
subwoofers can be activated.
> Check that the Adaptive Sound Technology
is enabled or disabled as you desire.
> Press the centre button to store and bring
up the next menu. If you have selected
OFF to disable the Adaptive Sound
Technology,
about how
to assign roles to speakers, set the speaker
distances and calibrate the sound level.
> Enter the horizontal distance in metres
between your listening position and each
speaker making a sound.
> If you are setting a customised preset and
ADAPTIVE SOUND TECHNOLOGY is
enabled, highlight ROTATION and select
how much the sound stage should be
rotated. A sound will be produced from
the setup if a source is playing and you
rotate until the sound is experienced from
the desired direction.
> Press the centre button to store and
return to the LISTENING PRESETS menu.
During first-time setup, press the green
button to continue the first-time setup
procedure when you have created the
desired presets.
Listening presets
>> Adaptive Sound Technology
Example of a listening position for watching
tele vision and Home cinema. You select which
speakers should be active for each situation.