Bang & Olufsen BeoVision 7-40/55 User Guide - Manual (Page 59)

59
The pincode system
The pincode system is intended
to make normal use of your
television impossible for
someone who does not know
the pincode. You choose
whether or not to activate the
pincode system.
When the pincode system is
activated and the television has
been disconnected from the
mains for 15–30 minutes, the
pincode system goes into effect.
When reconnected and switched
on, the television automatically
switches itself off after four
minutes. Entering the pincode
returns the television to normal.
Note: If you change your pincode more
than five times within a three-hour
period, the PINCODE menu becomes
inaccessible for three hours, assuming
that the television is not disconnected
from the mains. Disconnecting the
television resets the three-hour period.
Activate the pincode system
If you wish to deactivate the pincode
system, you can do so by deleting your
pincode.
To activate the pincode system …
> Bring up the TV SETUP menu.
> Press twice, followed by STOP. The
PINCODE menu appears on the screen.
> Enter the four digits of your code.
> Press the centre button after the last digit
is found.
> Re-enter your code to confirm it and press
the centre button again. If the two codes
are not identical, the input fields are
cleared and you must enter the code
again.
To change or delete your pincode …
> Bring up the TV SETUP menu.
> Press twice, followed by STOP. The
PINCODE menu appears on the screen.
> Enter the correct pincode and press the
centre button. DELETE PINCODE is
highlighted.
> To delete your code, press the centre
button.
> To change your code, use the navigation
button down to highlight NEW PINCODE
and press the centre button. Enter the
new code and press the centre button.
Re-enter the new code to confirm it.
If you inadvertently press a wrong button
while entering a code, press BACK. The
entry is cancelled and the input fields are
cleared.
PINCODE
PINCODE 0 . . .
CONFIRM PINCODE 0 . . .
PINCODE
DELETE PINCODE
NEW PINCODE