Bang & Olufsen BeoVision 7-40/55 User Guide - Manual (Page 71)

71
System modulator
If you have an audio setup, such as a
BeoLink Active/Passive, and you choose
to set up a non-linkable television in the
same room, you must set the sys tem
modulator to ON. The factory setting is
AUTO, which must be used if you are using
a linkable Bang & Olufsen television.
To switch on the system modulator …
> Bring up the TV SETUP menu and highlight
OPTIONS.
> Press the centre button to bring up the
OPTIONS menu and highlight
CONNECTIONS.
> Press the centre button to bring up the
CONNECTIONS menu, and highlight LINK.
> Press the centre button to bring up the
LINK menu and highlight MODULATOR.
> Use the navigation button left or right to
reveal ON.
> Press the centre button to store the
setting, or …
> … press and hold BACK to exit all menus
without storing.
>> Distribute sound and picture with BeoLink
If, for example, a TV channel in your
area is broadcasted on the same channel
as the factory setting for the BeoLink
system; channel 66, you must tune the
system modulator to an unoccupied
channel. When you change the link
channel in the main room television,
make sure that the link channel in the
link room television corresponds to it.
To change the link channel …
> Bring up the TV SETUP menu and highlight
OPTIONS.
> Press the centre button to bring up the
OPTIONS menu and highlight
CONNECTIONS.
> Press the centre button to bring up the
CONNECTIONS menu, and highlight LINK.
> Press the centre button to bring up the
LINK menu and highlight CHANNEL.
> Use the navigation button left or right to
find an unused channel.
> Press the centre button to store the
setting, or …
> … press and hold BACK to exit all menus
without storing.
The LINK menu.
When tuning in the link channel in the link
room, a test image is shown. FINE TUNE is
only available in link room/Option 4 setups.
Link channel
LINK
CHANNEL 66
MODULATOR AUTO