Bang & Olufsen BeoVision 7-40/55 User Guide - Manual (Page 44)

44
The television can be set to switch itself
to standby after some time with no
operation. The factory setting is 4 hours.
This function only applies in video mode
not in audio mode. You can also set your
television to save power.
To make standby settings …
> Bring up the TV SETUP menu and highlight
OPTIONS.
> Press the centre button to bring up the
OPTIONS menu and highlight STANDBY
SETTINGS.
> Press the centre button to bring up the
STANDBY SETTINGS menu and use the
navigation button up or down to move
between AUTO STANDBY and POWER
SAVING.
> Use the navigation button left or right to
select the setting you want.
> Press the centre button to store the setting.
> Press BACK to back up through previous
menus or press and hold BACK to exit all
menus.
When AUTO STANDBY is activated, a
message appears on your television screen if
the television has not been operated during
the time set in the menu. The television then
switches to standby, if you do not operate it.
When power saving is set to ON, there is no
light in the standby indicator.
STANDBY SETTINGS menu.
When no signal has been detected for
15 minutes, the television is switched to
standby.
If you want to make recordings on a
Bang & Olufsen hard disk recorder or use
Master Link to integrate your audio/video
system, or if you want external Play Timers
executed on the television, you must set
POWER SAVING to OFF to make your setup
function correctly.
>> Set the television to switch itself on or off
Standby settings
STANDBY SETTINGS
AUTO STANDBY 4 HOURS
POWER SAVING OFF