Bang & Olufsen BeoVision 7-40/55 User Guide User Manual
Page 19
19
If you have connected a cable box to the
television, you must register the
connection in the CABLE BOX SETUP
menu.
> Use the navigation button up or down to
highlight the name of your cable box.
> Press the centre button to store the
setting. You can then enter the output
channel for the cable box.
When you connect an RF cable box,
remember to leave it switched on at all times.
When you have registered the specific
cable box, enter the output channel for
the type of cable box and test whether
you can change channels on the box.
When the menu for your cable box
appears …
> Use the navigation button left or right to
select the channel number that
corresponds to the output channel set on
your cable box. Select CH2, CH3, CH4,
CH5 or CH6.
> Highlight CH TEST and use the navigation
button left or right to test whether you
can change channels on the box.
> If you cannot change channels on the
cable box, repeat the first two steps.
Otherwise …
> … press the centre button to store your
settings.
Select your cable box from the CABLE BOX
SETUP list. Above you see an example of a
CABLE BOX SETUP list. For installation of
external equipment, contact your retailer.
Select the output channel for your particular
cable box
>> Scan in TV channels
Identify the cable box
Source for RF input
GE CABLE BUDDY
OUTPUT CH
4
CH TEST
. .
CABLE BOX SETUP
NOKIA 98005
2
NOKIA D.BOX II
3
PACE DTR739-IM
4
PHILIPS DTX627x
5
PACE DSR600
6
SKY DIGITAL
7
CANALdig DK/S/N
8
CANALdigital I
9
. . . .
GE CABLE BUDDY
1