Bang & Olufsen BeoVision 7-40/55 User Guide - Manual (Page 23)

23
>> Edit scanned TV channels
You can add new channels or update
scanned channels which, for example,
have been moved by the broadcaster.
Note: If you re-scan all your TV channels,
all channel settings you have made
disappear!
> Bring up the TV SETUP menu and highlight
OPTIONS.
> Press the centre button to bring up the
OPTIONS menu and highlight TUNER
SETUP.
> Press the centre button to bring up the
TUNER SETUP menu. TV TUNER is already
highlighted.
> Use the navigation button right to select
the source of your TV video signals –
CABLE, CABLE BOX, ANTENNA or OFF –
and press the centre button to store it.
> If you select CABLE or ANTENNA, scanning
begins automatically. New channels are
added automatically as they are found.
If you only wish to check for a new signal on
a scanned channel that has been empty, do
not re-scan all TV channels. Instead, select
the channel in the channel list using the
number buttons on the remote control. For
further information about the channel list,
see Getting Started.
If you select CABLE BOX or OFF for TV
TUNER in the TUNER SETUP menu, the EDIT
CHANNELS and FINE TUNE menus are
inaccessible.
Re-scan TV channels
TUNER SETUP
TV TUNER CABLE
ATSC ON