Bang & Olufsen BeoVision 7-40/55 User Guide - Manual (Page 18)

18
Scan in TV channels
Register the source of your TV
signal and scan in your TV
channels.
If you have a connected cable
box to your television, you must
identify the cable box and select
an output channel.
If you have selected TV TUNER in the
TUNER SETUP menu, you can enter the
source of your TV video signals.
To scan in TV channels…
> Bring up the TV SETUP menu and highlight
OPTIONS.
> Press the centre button to bring up the
OPTIONS menu and highlight TUNER SETUP.
> Press the centre button to bring up the
TUNER SETUP menu. TV TUNER is already
highlighted.
> Use the navigation button left and right to
select CABLE, CABLE BOX, ANTENNA or
OFF.
> Press the centre button to store the
setting. If you have selected CABLE or
ANTENNA, scanning begins immediately.
If you have selected CABLE BOX, you can
then register your cable box in a menu, as
described
on page 19 .
Note that if you select OFF, you must register
a source in the CONNECTIONS menu as TV if
you wish to switch on the television using the
TV button on the remote control. For further
information about the CONNECTIONS menu,
see page 15 .
The TUNER SETUP menu.
Select video signal type
TUNER SETUP
TV TUNER CABLE
ATSC ON