KACO blueplanet 750 - 1000 kVA - Manual (Page 6)

Page 6 KACO blueplanet 1000/875/750 TL3 M1 IS OD DEX0
General Notes
1.1.7 Abbreviations
HMI Human Machine Interface RPC Remote Power Control
PEBB Power Electronics Building Block APS Anti-islanding method
PSI PEBB Signal Interface board ACI
protocol
Advanced Communication Interface
(KACO Communication protocol)
ASI Analog Signal Interface board PLL Phase Locked Loop
GUI Graphic User Interface XCU XP Control Unit (Inverter control system)
MPPT Maximum Power Point Tracking CAN Controller Area Network
MPP Maximum Power Point FPGA Field-Programmable Gate Array
Vdc PV Voltage DSP Digital Signal Processor
FRT Fault Ride Through ADC Analog to Digital Converter
CEI 0-16 Italia grid code NVSRAM Non-volatile Static RAM
1.2 Name plate
The name plate is located on the inside of the each door and the front of housing for DC cable connection.
1.3 Intended use
The inverter converts the DC power generated by the photovoltaic (PV) modules into AC power and feeds this
into the power grid. The inverter is built according to the state of the art and recognized safety rules. Neverthe-
less, improper use may cause lethal hazards for the operator or third parties, or may result in damage to the
unit and other property. The inverter may be operated only with a permanent connection to the public power
grid. In the event that the inverter is not provided with full protection against shock hazard on the PV array shall
be provided with installation instructions requiring that the inverter and the array must be installed in closed
electrical operating areas and indicating which forms of shock hazard protection are and are not provided inte-
gral to the inverter.
1.3.1 Earthing of PV array
The type of inverter must be chosen depending on earthing of PV array.
Earthing of PV array Type of PV inverter
Frame ground (Isolation) All type (IS, NG, PG)
Negative ground Negative ground type (NG)
Positive ground Positive ground type (PG)