KACO blueplanet 750 - 1000 kVA - Manual (Page 59)

KACO blueplanet 1000/875/750 TL3 M1 IS OD DEX0 Page 59
Faults and Warnings
6 Faults and Warnings
When a problem occurs in the system, the Inverter will inform the user on the Fault Lamp. The Inverter displays
two basic error messages in the CMT (Support the PC and the Mobile version). The first, the fault, is a serious
problem that causes the inverter to stop running. The second, a warning, is a minor problem that does not
cease the system operation. The CMT will indicate faults in red and warnings in yellow. The user can find a
description of the different fault and warnings in the following Tables.
6.1 Warning
Message Code Description
SP1(PV SP) Failure 81 Failure of the PV side surge protector (SP1)
CB10 (PV Contactor) Failure 82 PV side contactor (DS10) failure
PV Fuse Failure 83 PV side Fuse failure (option)
Ground Fault Warning 84 The insulation resistance of the PV falls short of the limit set in the
ground fault monitoring for Alert1 (option)
PV Over Voltage 85 PV voltage exceeds the parameter [DC over voltage Level]
PEBB Over Temp. Warning 100 The temperature of the PEBB (Power Electronics Building Block) over
85°C (185°F)
PEBB Fan Failure 101 Failure of a PEBB (Power Electronics Building Block) fan
PEBB Temperature Unbal-
ance 102 The Difference of each PEBB temperature exceeds the operational
parameter [PEBB Temperature Unbalance Level]
ASYNC Warning 111 Not synchronized between Inverter Voltage and Grid Voltage at Grid
Interconnection
Test Mode 120 The system is working in test mode
Watchdog 121 Abnormalities detection in the DSP
Invalid Parameter 125 Parameter is invalid value.
Reconnection Condition
Warning 126 The grid voltage or frequency exceeds the reconnection condition
when reconnection to grid during operational parameter [Reconnec-
tion Condition Warning Delay] seconds
Reactor Fan Failure 128 Failure of a Reactor FAN
Top Fan Failure 129 Failure of a Top FAN
Cabinet Over Temp.
Warning 130 The temperature of the cabinet over the parameter [Cabinet Tempera-
ture Maximum]
Cabinet Under Temp.
Warning 131 The temperature of the cabinet falls below the parameter [Cabinet
Temperature Minimum]
SP3(Control Power SP)
Failure 132 Failure of the control side surge protector (SP3)
CB32 Open 133 Failure of the top fan or power supply
SMPS Warning 134 Failure of the control SMPS (Switching Mode Power Supply)
Table 5: Warning