Yaskawa SmartTrac Fault Tables - Manual (Page 53)

10/17/00
New Berlin
Technology Center
Smart Trac
Product Development
Design Document
Faults.doc
Rev. # 19 Page 52 of 64
Title: Fault Declarations
The information contained in this document is the CONFIDENTIAL property of MagneTek Inc.
File = N:\PROJECT\515\SmartTrac\DOCS\Faults.DOC Print Date: 10/17/00
52
Displayed Fault
No.
Priority D
is
p
lay?
Newest
List
?
Ol
d
es
t
List
?
Severity
Assig
n
Program
Input
Corrective Action
Control
Node
Monitor
Fault
Manager
In
ternal Fault
No
.
Fault Legend Description
1757E 95614 30078 Not used
1757F 95615 30079 Not used
17580 95616 30080 Not used
17581 95617 30081 OPE1 Fault kVA Selection. Smart Trac AC1
capacity selection. The inverter’s
model number has been changed
from factory setting or inverter card
has been replaced from original. Yes Yes Yes Minor Major Change inverter parameter o2-04,
Inverter Model #, to correct value.
17582 95618 30082 OPE2 Fault Limit. Parameter set out of range.
Attempt is made to change an
inverter setting to a value outside
the permitted range. Yes Yes Yes Minor Major Do not attempt to change an inverter
parameter to a value outside the
permitted range. May need to do a 2-
wire reset to drive
17583 95619 30083 OPE3 Fault Terminal. Multi-function input
setting fault. Yes Yes Yes Minor Major Applies to inverter parameters H1-01
through H1-06: two or more
parameters are set to the same data –
other than ‘F’, ‘FF’, or 20 to 2F hex.
17584 95620 30084 Not used
17585 95621 30085 Not used
17586 95622 30086 OPE6 Fault PG Opt Missing. PG card not
installed. Yes Yes Yes Minor Major Control method set to flux vector or
V/F with PG, and no PG card is
installed. Ensure that A1-02= 1 or 3.
17587 95623 30087 Not used
17588 95624 30088 Not used
17589 95625 30089 Not used