Yaskawa SmartTrac Fault Tables - Manual (Page 24)

10/17/00
New Berlin
Technology Center
Smart Trac
Product Development
Design Document
Faults.doc
Rev. # 19 Page 23 of 64
Title: Fault Declarations
The information contained in this document is the CONFIDENTIAL property of MagneTek Inc.
File = N:\PROJECT\515\SmartTrac\DOCS\Faults.DOC Print Date: 10/17/00
23
Displayed Fault
No.
Priority D
is
p
lay?
Newest
List
?
Ol
d
es
t
List
?
Severity
Assig
n
Program
Input
Corrective Action
Control
Node
Monitor
Fault
Manager
In
ternal Fault #
Fault Legend Description
12AFE 76542 11006 PG Card ID
Error The PG card can’t be found. This is
due to the software not seeing the
correct identification code on the PG
card. Yes Yes Yes Minor Major The correct PG card must be installed for
the Smart Trac AC1 function blocks
used.
12AFF 76543 11007 PG A/D
Retries The PG_ANALOG_IN function
block senses that the PG card has not
done an analog to digital conversion
in the allotted time after the number
of attempts set by the TriesB4Fault
input to the PG_ANALOG_IN
block. No Yes Yes Minor Minor Try increasing the number of attempts
for conversion, TriesB4Fault, to a higher
value. Possibility the PG card is
defective.
12B00 76544 11008 I/O Memory
Alloc Dynamic RAM was not available for
use by one or more Function Blocks. Yes Yes Yes Minor Major These Function Blocks require use of
DRAM: CAVE, LDelay, NDelay, and
REFQ. One of these FBs was unable to
allocate memory to support its function.
Recycle power to Smart Trac AC1. If
problem persists, replace Smart Trac
CPU card.