Yaskawa i80M Maintenance Manual - Manual (Page 213)

8.2 DISPLAY AND WRITING OF FIXED FILES
Each fixed file permits screen display, writing, and 1/0
verification.
Table 8.1 Display, Writing, and Verification of Fixed Files
I t e m
Parameter
P a r a m e t e r
Display Screen and
Write Process
System No.
Interlock ,
System No.
Interlock
Maintenance Available Maintenance Available
maintenance, Drive Not available Maintenance Not available
Maintenance Available Maintenance Available
Maintenance Available Maintenance Available
Step
I Not available Maintenance Not available
Offset
Coordinate System
Step Not available Maintenance
I
T OO I Life Management Step Not available Maintenance Not available
Macro Program Common Variable Drive Not available Maintenance Not available
I I
System number and interlock have the following rules:
2.
3.
4.
5.
For writing of parameters and keep memory, system number must be set to 1.
A system number is set by the parameter replacement switch on the control panel
or to the value
Setting of parameter replacement switch
OFF: SYSTEM ( pmO109 = O). Normal operation is performed
Writing of parameters is prohibited,
ON: PARAMETER = 1). Selected to write parameters.
Cycle start is prohibited.
When other than the values shown above is specified, normal operation cannot be
guaranteed.
Effective only when the system number switch on the board is set to O.
System number setting must be used as O, except when writing parameters
205