Yaskawa i80M Maintenance Manual User Manual
Page 133
4.3.13 FIN WAIT OCCURS BY SPINDLE RELATED INSTRUCTION
The seq
and was
Cause of Trouble
A signal identical with
the spindle speed is not
entered.
The axis zero speed
signal is not entered.
Other
processing entered some signal wait mode
then discontinued.
4 . 4 2 Fin Wait
O c c u r s
C h e c k M e t h o d
S o l u t i o n
I
If this trouble occurs at the time of
If no trouble is found in the
issuing such as “ M03 S1OO”, etc., confirm
wiring, there is a
1/0 signal
= 1
for
ity of a fault model JAN CD-
2nd-spindle).
board or fault spindle
Refer to the circuit diagram of the machine
drive unit.
manufacturer to confirm 1/0 input section
Contact your
1/0 signal #1000 level.
representative.
If this trouble occurs at stop time “ M05°,
If no trouble is found in the
refer to the circuit diagram of the machine
wiring, there is a
manufacturer to confirm 1/0 input section
ity of a fault model
-
1/0 signal #1000 level.
FC800 board or fault spindle
drive unit.
If this trouble occurs at the time of “ M19°
If no trouble is found in the
or “M20”, spindle orientation command,
wiring, there is a possibility
refer to the circuit diagram of the machine
of a fault model
-
manufacturer to confirm the 1/0, especially
FC800 board or fault spindle
the orientation-related sections.
drive unit.
Contact your
representative.
125