2 machine control station, Cent’d) – Yaskawa i80M Maintenance Manual User Manual

Page 196

6.2 MACHINE CONTROL STATION

(Cent’d)

6.2.1.3 MODEL JANCD-FC903-1

MOUNTING SCREW

M O U N T I N G S C R E W

MOUNTING SCREW

(1) Removal

( a )

Check that AC input power is not supplied [the
SOURCE indication lamp (green ) of the power unit

is off], then pull out cables connected to CN21,

CN24, CN25,

CN28, and CN29 of model

( b )

JANCD-FC903-1O

Loosen the mounting screws of model
and remove model JANCD-FC903 from

panel.

(2) Installation

See the figure for the exterior of the

( a )

( b )

( d )

Check the model and REV number of

module for consistency.

Check that the setting of

is the

before replacement.

the control

module.

the replacement

same as that

Install model JAN

on the control panel

according to the figure.

Insert all cables to the original positions.

188