Yaskawa i80M Maintenance Manual - Manual (Page 207)

■
Model JANCD-FC400
Swl : System number switch (16-position rotary switch)
[11:
[ 2 ] :
[41:
Normal operation mode
When power is applied, the system is
started up in synchronization with NC
and an application program (index )
is executed immediately.
NC built-in program development mode
When power is applied, the system is
started up in synchronization with NC
and the screen of application program
development mode is displayed.
Stand-alone execution mode
When power is applied, is
started up singly and an application
program (index “ ) is executed
immediately.
Stand-alone program development mode
When power is applied, ACGC is
started up singly and the screen of
application program development mode
is displayed.
SW [3], and [5] to [F] are
used only for maintenance.
Only YASKAWA service personnel
must use these switches.
199