Yaskawa i80M Maintenance Manual - Manual (Page 122)

4.3 TROUBLESHOOTING WITHOUT ALARM CODES (Cent’d)
Cause of Trouble
Power is not supplied
to HANDLE PG.
Two or three handles
HANDLE PG trouble
FC903 board trouble
Manual pulsing
magnification input is
selected.
Others: Related para-
meters
Table 4.33 (Cent’d)
check
that +5 V is supplied on terminal of
PG.
that the HANDLE PG signal
is not removed.
‘his is a counter monitor.
that #3037 (one handle), #3038 (two
#3o39 (three handles) values changes
HANDLE PG is turned.
Manual pulsing magnification
input 1/0 signal #3002
I
D 6
I
D 5
I
-
M P4 MP2 MP1 cation
o 0 0
x l
o 1 x 1 0
0 1 0 1 0 0
0 1 1 x 1 0 0
1
Either O or 1 x 100
The max in HANDLE mode
(linear axis)
(rotation axes)
at in ‘HANDLE
mode
pm2561 - pm2568
Optional magnification setting at magnifica-
tion 100 selection time
(For pm2003 1)
pm2459
Solution
to “ Manual pulse
of the
Manual to
the wiring, and wire
option parameters.
HANDLE PG.
wiring of the
setting switch.
Verify it with the para-
meter table attached at
the factory prior to
shipment.
114