SMA SUNNY WEBBOX - Manual (Page 45)

SMA Solar Technology AG 7 System Monitoring
User Manual SPortal-WB-CLCON-BA-en-25 45
7.3.3 Setting Inverter Comparison
Depiction of the inverters in groups or individually:
The inverters are depicted as a group if they are of the same type, have the same set tolerance and
have been selected for inverter comparison. If at least one feature is different, the inverters will be
listed individually.
1. Select "Plant name > Plant monitoring".
2. In the "Inverter Comparison" area, select [Settings].
3. Enter the recipient's e-mail address for notifications in the "Recipient" field. If you enter several
e-mail addresses, please separate these by commas.
4. If necessary, change the preset generator power in the "Generator power [kWp]" field.
Sunny Portal calculates the generator power based on the nominal power of the inverter. You
can configure the generator power for each inverter (see Section 10.2.5 ”Setting the Generator
Capacity” (page 65)).
5. In the "Tolerance [%]" field, change the permitted preset tolerance for inverter specific yield, if
necessary. If the specific yield is outside the tolerance range, Sunny Portal will inform you by
e-mail.
6. Activate the "Monitoring" field for the desired inverters. By doing this, the inverters will be
selected for the inverter comparison.
7. Select [Save].
7.3.4 Setpoint Monitoring: Setting the E-Mail Alert
Requirements:
☐ The Cluster Controller/Power Reducer Box is registered in Sunny Portal (see user manual of the
Cluster Controller/Power Reducer Box).
☐ The use of Sunny Portal is activated in the Cluster Controller/Power Reducer Box (see user
manual of the Cluster Controller/Power Reducer Box).
1. Select "Plant name > Plant monitoring".
2. In the "Setpoint monitoring" area, select [Settings].
3. To receive an alert by e-mail:
– Activate field "Send alert whenever control commands are received from grid operator".
– Enter the recipient's e-mail address for notifications in the "Recipient" field. If you enter several
e-mail addresses, please separate these by commas.
4. If you do not wish to receive an alert, deactivate the field "Send alert whenever control
commands are received from grid operator".
5. Select [Save].