HEIDENHAIN PWM 8 - Manual (Page 11)

- 11 -
3. Operation
3.1 Display after Power-On
Software-Id.No. 246 199-xx;
the last two places symbolize the software
version (here: version 01)
Automatic recognition of the interface board
(here: TTL interface)
EXPERT MODE is active;
see section 5
Software compensation data
(for calibration by HEIDENHAIN staff)
Note on software compensation data:
The software compensation display is intended for calibration by HEIDENHAIN staff.
The settings displayed can only be changed by HEIDENHAIN, Traunreut.
3.2 Standard Soft-Key Row
After the power-on display, the standard soft-key row is displayed.
Possibilities of setting the standard soft-key row:
Switches to the soft-key row PWM 8 MODE
(see PWM 8 MODE in section 4)
Assignment of the BNC sockets A, B and C to different encoder signals;
after pressing the BNC soft-key, you can choose from the following options:
By pressing this soft key the BNC sockets A
to C can be assigned to the encoder signals
from memory 1 to 3.
Terminate assignment of BNC sockets
The default setting of the BNC memories made by HEIDENHAIN can be changed any time.