HEIDENHAIN iTNC 530 (340 49x-01) - Manual (Page 8)

8
Functions changed since the predecessor
versions 340 422-xx and 340 423-xx
„ The layouts of the status display and additional status display were
redesigned (see “Status Displays” on page 43).
„ Software 340 490 no longer supports the small resolution in
combination with the BC 120 screen (see “Visual display unit” on
page 37).
„ New key layout of the TE 530 B keyboard unit (see “Operating
panel” on page 39)
„ The entry range for the EULPR precession angle in the PLANE
EULER function was expanded (see “Defining the Machining Plane
with Euler Angles: EULER PLANE” on page 460).
„ The plane vector in the PLANE EULER function no longer has to be
entered in standardized form (see “Defining the Machining Plane
with Two Vectors: VECTOR PLANE” on page 462).
„ Positioning behavior of the CYCL CALL PAT function modified (see
“Calling a cycle in connection with point tables” on page 271)
„ The tool types available for selection in the tool table were increased
in preparation for future functions.