HEIDENHAIN iTNC 530 (340 49x-01) - Manual (Page 191)

HEIDENHAIN iTNC 530 191
6.4 P
a
th Cont
ours—Car
te
sian Coor
dinat
e
s
Straight Line L
The TNC moves the tool in a straight line from its current position to
the straight-line end point. The starting point is the end point of the
preceding block.
8 Coordinates of the end point of the straight line
Further entries, if necessary:
8 Radius compensation RL/RR/R0
8 Feed rate F
8 Miscellaneous function M
Example NC blocks
Actual position capture
You can also generate a straight-line block (L block) by using the
ACTUAL-POSITION-CAPTURE key:
8 In the Manual Operation mode, move the tool to the position you
wish to capture.
8 Switch the screen display to Programming and Editing.
8 Select the program block after which you want to insert the L block.
8 Press the ACTUAL-POSITION-CAPTURE key: The
TNC generates an L block with the actual position
coordinates.
7 L X+10 Y+40 RL F200 M3
8 L IX+20 IY-15
9 L X+60 IY-10
In the MOD function, you define the number of axes that
the TNC saves in an L block (see “MOD Function” on
page 572).
X
Y
60
15
40
10
10
20