HEIDENHAIN iTNC 530 (340 49x-01) - Manual (Page 589)

HEIDENHAIN iTNC 530 589
13.7 Configur
ing PGM MGT
Dependent files
In addition to the file extension, dependent files also have the
extension .SEC.DEP (SECtion, DEPendent). The following different
types are available:
„ .H.SEC.DEP
The TNC creates files with the .SEC.DEP extension if you work with
the structure function. The file contains information needed by the
TNC to rapidly jump from one structure point to the next.
„ .T.SEC.DEP : Tool usage file for individual conversational-format
programs
The TNC creates files with the .T.DEP extension if
„ bit 2 of the machine parameter 7246=1 is set
„ the machining timer is active in the Test Run operating mode
„ a plain language program is being run in the Test run mode
„ .P.T.SEC.DEP : Tool usage file for a complete pallet
The TNC creates files with the .P.T.DEP ending if, in a program run
mode, you run the tool usage test (see “Tool usage test” on page
590) for a pallet entry of the active pallet file. This file then lists the
sum of all tool usage times of all tools that you use within a pallet.
In a tool usage file, the TNC saves the following information:
Column Meaning
TOKEN „ TOOL : Tool usage time per TOOL CALL. The
entries are listed in chronological order.
„ TTOTAL : Total usage time of a tool
„ STOTAL : Call of a subprogram (including
cycles). The entries are listed in
chronological order.
TNR Tool number (–1: No tool inserted yet)
IDX Tool index
NAME Tool name from the tool table
TIME Tool usage time in seconds
RAD Tool radius R + Oversize of tool radius DR
from the tool table. The unit is 0.1 µm
BLOCK Block number in which the TOOL CALL block
was programmed
PATH „ TOKEN = TOOL: Path name of the active main
program or subprogram
„ TOKEN = STOTAL: Path name of the
subprogram