HEIDENHAIN iTNC 530 (340 49x-01) - Manual (Page 512)

512 11 Programming: Q Parameters
1
1
.7 Chec
king and Changing Q
P
ar
amet
ers
11.7 Checking and Changing
Q Parameters
Procedure
You can check and edit Q parameters when writing, testing and
running programs in the Programming and Editing, Test Run, Program
Run Full Sequence, and Program Run Single Block modes.
8 If you are in a program run, interrupt it if required (for example, by
pressing the machine STOP button and the INTERNAL STOP soft
key). If you are in a test run, interrupt it.
8 To call Q parameter functions: Press the Q key or the
Q INFO soft key in the Programming and Editing
mode of operation.
8 The TNC lists all parameters and their current values.
With the arrow keys or the soft keys, go pagewise to
the desired parameters.
8 If you would like to change the value, enter a new
value and confirm with the ENT key.
8 To leave the value unchanged, press the PRESENT
VALUE soft key or end the dialog with the END key.
The parameters used by the TNC are provided with
comments.