HEIDENHAIN iTNC 530 (340 49x-01) - Manual (Page 443)

HEIDENHAIN iTNC 530 443
8.9
Coor
di
na
te
T
ra
n
s
for
m
a
ti
on Cy
cle
s
5 Set the datum
„ Manually by touching the workpiece with the tool in the untilted
coordinate system (see “Datum Setting (Without a 3-D Touch
Probe)” on page 62).
„ Controlled with a HEIDENHAIN 3-D touch probe (see the Touch
Probe Cycles Manual, chapter 2).
„ Automatically by using a HEIDENHAIN 3-D touch probe (see the
Touch Probe Cycles Manual, chapter 3).
6 Start the part program in the operating mode Program Run, Full
Sequence
7 Manual Operation mode
Use the 3-D ROT soft key to set the TILT WORKING PLANE function
to INACTIVE. Enter an angular value of 0° for each axis in the menu
(see “Activating manual tilting” on page 74).