HEIDENHAIN iTNC 530 (340 49x-01) - Manual (Page 617)

HEIDENHAIN iTNC 530 617
14.1 Gener
a
l User P
a
ra
met
e
rs
Reset status display, Q
parameters, tool data
and machining time MP7300
Reset all when a program is selected: 0
Reset all when a program is selected and with M02, M30, END PGM: 1
Reset only status display and tool data when a program is selected: 2
Reset only status display, machining time and tool data when a program is selected and with
M02, M30, END PGM: 3
Reset status display, machining time and Q parameters when a program is selected: 4
Reset status display, machining time, and Q parameters when a program is selected and with
M02, M30, END PGM: 5
Reset status display and machining time when a program is selected: 6
Reset status display and machining time when a program is selected and with M02, M30, END
PGM: 7
Graphic display mode MP7310
Projection in three planes according to ISO 6433, projection method 1: +1
Projection in three planes according to ISO 6433, projection method 2: +1
Do not rotate coordinate for graphic display: +0
Rotate coordinate system for graphic display by 90°: +2
Display new BLK FORM in Cycle 7 DATUM SHIFT referenced to the old datum: +0
Display new BLK FORM in Cycle 7 DATUM SHIFT referenced to the new datum: +4
Do not show cursor position during projection in three planes: +0
Show cursor position during projection in three planes: +8
Software functions of the new 3-D graphics active: +0
Software functions of the new 3-D graphics inactive: +16
Limitation of a tool’s
tooth length to be
simulated. Only
effective if LCUTS is
not defined. MP7312
0 to 99 999.9999 [mm]
Factor by which the tool diameter is multiplied in order to increase the simulation speed. If 0 is
entered, the TNC assumes an infinitely long tooth length, which increases the simulation speed.
Graphic simulation
without programmed
tool axis: Tool radius MP7315
0 to 99 999.9999 [mm]
Graphic simulation
without programmed
tool axis: Penetration
depth MP7316
0 to 99 999.9999 [mm]
Graphic simulation
without programmed
tool axis: M function
for start MP7317.0
0 to 88 (0: function inactive)
Graphic simulation
without programmed
tool axis: M function
for end MP7317.1
0 to 88 (0: function inactive)
Screen saver
Enter the time after
which the TNC should
start the screen saver
MP7392
0 to 99 [min] (0: function inactive)
TNC displays, TNC editor