HEIDENHAIN iTNC 530 (340 49x-01) - Manual (Page 6)

6
In addition, the iTNC 530 also has two software option packets that
can be enabled by you or your machine tool builder. Each packet is to
be enabled separately and contains the following respective functions:
Please contact your machine tool builder to become familiar with the
features of your machine.
Many machine manufacturers, as well as HEIDENHAIN, offer
programming courses for the TNCs. We recommend these courses as
an effective way of improving your programming skill and sharing
information and ideas with other TNC users.
Location of use
The TNC complies with the limits for a Class A device in accordance
with the specifications in EN 55022, and is intended for use primarily
in industrially-zoned areas.
Software option 1
Cylinder surface interpolation (Cycles 27, 28, 29 and 39)
Feed rate in mm/min on rotary axes: M116
Tilting the machining plane (Cycle 19 and 3D-ROT soft key in the
manual operating mode)
Circle in 3 axes (with tilted working plane)
Software option 2
Block processing time 0.5 ms instead of 3.6 ms
5 axis interpolation
Spline interpolation
3-D machining:
„ M114: Automatic compensation of machine geometry when
working with tilted axes
„ M128: Maintaining the position of the tool tip when positioning
with tilted axes (TCPM)
„ FUNCTION TCPM: Maintaining the position of the tool tip when
positioning with tilted axes (TCPM) in selectable modes.
„ M144: Compensating the machine’s kinematic configuration for
ACTUAL/NOMINAL positions at end of block
„ Additional parameters finishing/roughing and tolerance for
rotary axes
in Cycle 32 (G62)
„ LN blocks (3-D compensation)
Touch Probe Cycles User’s Manual:
All of the touch probe functions are described in a separate
manual. Please contact HEIDENHAIN if you require a copy
of this User’s Manual. ID number: 375 319-xx.