HEIDENHAIN SW 68894x-03 - Manual (Page 83)

HEIDENHAIN CNC PILOT 640 83
3.3 Mac
h
ine data
Override display of the active spindle
 F: Feed rate
 R: Rapid traverse
 S: Spindle
Utilization of the drives: Utilization of the drive relative to the rated torque.
 Digital axis and spindle motors
 Analog axis and spindle motors, if set up by the machine tool builder
Display of unit quantities: The quantity is incremented after each M30, M99 or
M18 programmed counter pulse.
 MP: Default unit quantity
 P: Number of finished parts
Display of unit quantities and time per unit: The quantity is incremented after
each M30, M99 or M18 programmed counter pulse.
 MP: Default unit quantity
 P: Number of finished parts
 t: Run time of the current program
 Sum t: Total time
Display of skip levels and M01 conditional stop
 Defined skip levels (upper row) and set/activated skip levels (lower row)
 Setting for M01: M01 is not executed in Continuous Run mode (yellow display)
Display of rear-face machining: The RSM display (RSM: Rear Side Machining)
provides information about rear-face machining.
 RSM status
 Active zero point shift of the configured RSM axis
B-axis display: The information displayed about the status of the tilted plane varies
depending on the setting of the machine parameters.
 Programmed angular value of the B axis
 Display of the current values I, K, U and W
 I: Plane reference in X
 K: Plane reference in Z
 U: Shift in X
 W: Shift in Z
Elements of machine data display
The machine data display is configurable by the machine
tool builder. The machine data that appear on your screen
may therefore deviate from the example shown.