HEIDENHAIN SW 68894x-03 - Manual (Page 344)

344 Teach-in mode
4.8 Milling cy
cles
Example of milling cycle
Milling on the face
In this example, a pocket is milled. The milling example in "9.8 ICP
Example, Milling Cycle" illustrates the complete machining process on
the face, including contour definition.
The machining process is performed with the cycle ICP contour,
axial.
To describe a contour, define the basic contour first. Then
superimpose the rounding arcs.
Tool data (milling cutter)
 TO = 8 (tool orientation)
 I = 8 (milling diameter)
 K = 4 (number of teeth)
 TF = 0.025 (feed per tooth)