HEIDENHAIN SW 68894x-03 - Manual (Page 79)

HEIDENHAIN CNC PILOT 640 79
3.3 Mac
h
ine data
TSF dialog box with input of all cutting data
Select Set T, S, F (only available in Manual mode)
Define the parameters
Conclude data input
TSF dialog box with separate dialogs
Select Set T, S, F (only available in Manual mode)
Select T for tool change
Select S for setting the spindle speed
Select F for setting the feed rate
Enter the parameters in the submenu
Conclude data input
Selecting the workpiece spindle (machine-dependent)
If your machine is equipped with a workpiece spindle, the WP
parameter is shown in the TSF form. The WP parameter allows you to
select the workpiece spindle for machining in Teach-in mode and MDI.
Soft keys for "Set T, S, F"
Siehe „Tool compensation” auf
Seite 107.
Siehe „Touch off” auf Seite 104.
Call the tool list. Transfer of T number
from the tool list: Siehe „Setting up a tool
list” auf Seite 85.
Transfer of cutting speed and feed rate
from the technology data.
 On: Feed per minute (mm/min)
 Off: Feed per revolution (mm/rev)
 On: Constant speed (rpm)
 Off: Constant surface speed (m/min)
ENTER THE TOOL DATA AND TECHNOLOGY DATA
Caution. Depending on the machine, this operation might
cause the turret to turn.
ENTER THE TOOL DATA OR TECHNOLOGY DATA
Caution. Depending on the machine, the input of data in
the T dialog might cause the turret to turn.