HEIDENHAIN SW 68894x-03 - Manual (Page 109)

HEIDENHAIN CNC PILOT 640 109
3.7 Manual mode
Manual direction keys
With the manual direction keys, you can move the axes at the
programmed feed rate or at rapid traverse. Enter the feed rate in the
TSF dialog box
.
Teach-in cycles in Manual mode
 Set the spindle speed
 Set the feed rate
 Insert tool, define T number and check tool data (T0 is not permitted)
 Approach cycle start point
 Select the cycle and enter cycle parameters
 Graphically check the cycle run
 Run the cycle
 Feed rate
 If the spindle is rotating: Feed per revolution [mm/
rev]
 If the spindle is not rotating: Feed per minute [m/
min]
 Feed rate in rapid traverse: Feed per minute [m/min]
The entries last made in a cycle dialog remain in memory
until a new cycle is selected.