HEIDENHAIN SW 68894x-03 - Manual (Page 600)

600 Organization mode of operation
8.3 T
ransf
er
Importing NC programs from predecessor
controls
The program formats of the predecessor controls MANUALplus 4110
and CNC PILOT 4290 differ from the format of the CNC PILOT 640.
However, you can use the program converter to adapt programs of the
predecessor control to the new control. This converter is a component
of the CNC PILOT. The converter completes the required adaptations
as automatically as possible.
Overview of convertible NC part programs:
 MANUALplus 4110
 Cycle programs
 ICP contour descriptions
 DIN programs
 CNC PILOT 4290: DIN PLUS programs
TURN PLUS programs of the CNC PILOT 4290 cannot be converted.
Importing NC programs from the connected data medium
Press the Transfer soft key (login required).
Open the menu with the miscellaneous functions.
Open the menu with the import functions.
Selection of cycle programs or ICP contours of the
MANUALplus 4110 (*.gtz).
Selection of DIN programs ...
... of the MANUALplus 4110 (*.nc/ *.ncs).
Selection of DIN programs ...
... of the CNC PILOT 4290 (*.nc/ *.ncs).